Operation; Initial Operation; Switch On/Off; Settings - Festool CLEANTEX CTL 48 E LE EC Notice D'utilisation D'origine

6

Operation

WARNING
Unauthorised voltage or frequency!
Risk of accident
The mains voltage and the frequency of
the power source must correspond with
the specifications on the machine's name
plate.
In North America, only Festool machines
with the voltage specifications 120 V/60
Hz may be used.
6.1

Initial operation

Open the locking clips
the top section of the machine[2-1].
Remove the accessories from the dust
container [2-3] and the packaging!
Insert a filter bag in the dust container
that fulfils statutory requirements (see
chapter 7.8).
Replace the top section
the locking clips [2-2].
Attach the cable holder to the rear of the
mobile dust extractor (see Fig. [3]).
Only CTM 48 E LE EC: Insert the sealing
plug [1-1] on the panel (see Fig.
Connect the suction hose to the machine.
6.2

Switch on/off

Insert the plug into an earthed socket.
CAUTION
Risk of injury from tools starting up un-
expectedly
Before setting the switch to the "AUTO" or
"MAN" position, make sure that the con-
nected tool is switched off.
The switch [1-9] serves as an on/off switch.
Switch position "0"
Appliance socket [1-11]
the power, mobile dust extractor is switched
off.
"MAN" switch position
Appliance socket [1-11]
power, the mobile dust extractor starts.
[2-2] and remove
[2-1] and close
[1] ).
is disconnected from
is connected to the
CTM 48 E LE EC, CTL 48 E LE EC
"Auto" switch position
Appliance socket [1-11]
power, the mobile dust extractor starts when
the connected tool is switched on.
7

Settings

7.1 Adjusting the hose diameter
(only CTM 48 E LE EC)
Adjust the hose diameter adjuster
to match the diameter of the connected
hose.
The monitoring devices will measure the
air speed in the extractor hose correctly
as a result (see chapter 7.9).
7.2 Connecting electric power tools
WARNING
Risk of injury
Observe the maximum connected loads
for the appliance socket (see chapter
"Technical data").
Make sure that the power tool is switched
off before connecting or disconnecting.
Connect the electric power tool to the ap-
pliance socket [1-11].
7.3

Connecting pneumatic tools

WARNING
Risk of injury
Make sure that the pneumatic tool is
switched off before connecting or discon-
necting.
With the compressed air module [1-3], the
automatic switch-on function for the mobile
dust extractor also works in conjunction with
air tools.
We also recommend installing the VE service
unit (495886). The service unit filters and lu-
bricates the compressed air and enables an
adjustment of the air pressure. An IAS
adapter (454757) is available to connect Fes-
tool air tools to the IAS system.
The operating pressure of the tool must be 6
bar for the automatic switch-on unit to func-
tion correctly.
GB
is connected to the
[1-8]
15