Settings - Festool CTL 48 E LE EC/B22 R1 Notice D'utilisation D'origine

The use of extension cables in Zone 22 is
not permitted.
CAUTION
Risk of injury from tools starting up unex­
pectedly
► Before setting the switch to the "AUTO" or
"MAN" position, make sure that the con­
nected tool is switched off.
The switch [1-9] serves as an on/off switch.
Switch position "0"
Appliance socket [1-11] is disconnected from
the power, mobile dust extractor is switched
off.
"MAN" switch position
Appliance socket [1-11] is connected to the
power, the mobile dust extractor starts.
"Auto" switch position
Appliance socket [1-11] is connected to the
power, the mobile dust extractor starts when
the connected tool is switched on.
7

Settings

7.1 Adjusting the hose diameter
► Adjust the hose diameter adjuster [1-10] to
match the diameter of the connected hose.
The monitoring devices will measure
the air speed in the extractor hose
correctly as a result (see chap­
ter Volumetric flow monitoring).
7.2 Connecting electric power tools
WARNING
Risk of explosion, risk of injury
► Do not use the appliance's socket in zone
22.
► Observe the maximum appliance socket
connected load (see chapter "Technical da­
ta")
► Switch off the electric power tool.
► Connect the electric power tool to the appli­
ance socket [1-11].
7.3 Connecting pneumatic tools
WARNING
Risk of injury
► Switch off the air tool.
With the compressed air module [1-3], the au­
tomatic switch-on function for the mobile dust
extractor also works in conjunction with air
tools.
We also recommend installing the VE service
unit (495886). The service unit filters and lubri­
cates the compressed air and enables an ad­
justment of the air pressure. An IAS adapter
(454757) is available to connect Festool air tools
to the IAS system.
The operating pressure of the tool must be 6
bar for the automatic switch-on unit to function
correctly.
7.4 Connecting the energy box
The connection for the energy box (EAA) [1-4]
allows you to connect the mobile dust extractor
with the EAA in order to couple the automatic
switch-on unit on the mobile dust extractor with
the equivalent unit on the EAA.
7.5 Adjusting the suction power
► Use the rotary knob .
7.6 Applying the brake
Folding out the black brake lever [1-15] pre­
vents the mobile dust extractor from rolling. To
achieve this, lift the front end of the mobile dust
extractor slightly and push the black brake lev­
er downwards until it latches into place. Push
the green lever again to release.
7.7 Temperature cut-out
A temperature cut-out switches the mobile dust
extractor off when it reaches a critical tempera­
ture to prevent overheating.
► A temperature cut-out switches the mobile
dust extractor off when it reaches a critical
temperature to prevent overheating.
► Switch off the mobile dust extractor and al­
low to cool for approx. 5 minutes.
► Change the cooling air filter if necessary
(see chapter 9.2
If the mobile dust extractor will not
switch on again, please contact a Fes­
tool service workshop.
7.8 Changing the filter bag (SC-FIS-CT 48)
Removing the filter bag [4]
► Open the locking clips [2-2] and remove the
top section of the machine [2-1].
► Remove the filter bag.
► Dispose of the used filter bag in accordance
with statutory regulations.
).
English
17