Storing Your Own Sound Modes - JVC KD-AR3000 Manuel D'instructions

Storing your own sound modes

You can adjust the sound modes to your
preference and store your own adjustments in
memory (USER 1, USER 2, and USER 3).
• There is a time limit in doing the following
procedure. If the setting is canceled before you
finish, start from step 1 again.
1
Press SEL (select) once.
The last selected sound mode
is called up.
The next-step-operation
buttons start flashing.
Ex.: If you have selected "Country" previously
2
Select the sound mode you want to
adjust.
• This unit has two sound mode selection
screens. To move to the other screen,
press 5 (up) or ∞ (down).
3
Enter the sound adjustment mode.
The following sound
mode adjustment screen
appears on the display.
4
Make adjustments as you like.
Press ¢
1)
frequency band—60Hz, 150Hz, 400Hz,
1kHz, 2.4kHz, 6kHz, 12kHz.
Press 5 (up) or ∞ (down) to adjust the
2)
level of the selected band within the
range of –05 to +05.
3)
Repeat steps 1) and 2) to adjust the
other frequency bands.
5
Store the adjustment you made.
The confirmation message
appears—whether you want to
store the adjustment.
If you want to cancel the adjustments,
press D DISP.
6
Select one of the user sound modes
(USER 1, USER 2, or USER 3) you
want to store into.
Ex.: When you select "User 1"
or 4
to select the
27