Electrical Connection; Short-Circuits; Internal Housing Installation - Maico EV 31 Instructions De Montage Et Mode D'emploi

GB

Electrical connection

Danger to life from electric
shock
 Switch the mains fuse off.
DANGER
Unit damage in the case of

short-circuits

 Cut off and insulate any
CAUTION
unnecessary cable cores.
Danger of short-circuits
through incorrect feeding of
the power cable into the
CAUTION
housing.
 Feed the power cable
professionally through the
cable grommet and make sure
there is tension relief. See
printed cable run.
 Locate both cable grommets [5] in the
connecting flange.
 Feed the power cable through the open
cable grommet.
 Connect the power cable to the connection
terminal socket [9] as shown in the wiring
diagram on Page 25.
14

Internal housing installation

see also Figure A, bottom right
Danger of short-circuits and
unit damage with wrong
polarity
CAUTION
 Make sure the polarity is
correct, see labels A and B.
Damage to the contact holder
NOTICE
caused by tearing or pulling
on the plug cable
 Always hold the internal
housing near the connecting
flange to avoid pulling tension
at plug connection.
 Plug the connection terminal plug [12] on to
the connection terminal socket [9].
 Push the internal housing parallel onto the
connecting flange as shown bottom right in
Figure A.
The internal housing must clip into
i
the upper locking hooks [3.1].
Don't trap the cables.
 Close both catches [13] with a screwdriver.
 Switch the mains fuse on.
 Carry out a function test.