Air Ducting, Ventilation Circuit; Optional Outside Air Pre-Filter - Helios AIR1 XH 1000-8500 Notice De Montage Et D'entretien

Installation and Operating Instructions
EN
+
NOTE
m
DANGER
Central ventilation units AIR1 XH
R
T
W
– Fasten the duct, connecting piece and flexible duct connector in the corners of the unit with screws M8x16.
– After tightening the screws, the accessory must also be fastened using the mounting brackets (see Fig. 14).

2 .1 .7 Air ducting, ventilation circuit

When designing the ductwork, use the shortest possible runs.
Airtight connections and changeovers must be ensured for the best possible heat recovery.
Outside and outgoing air pipes are to be insulated in an appropriate way to reduce condensation.
If supply and extract air ductwork runs through unheated rooms, insulation must be provided to reduce heat losses.
All fire protection regulations must be observed!

2 .1 .8 Optional outside air pre-filter

The pre-filter ePM10 50 % (optional) is used to prevent the contamination of the fine filter.
m
Danger to life due to electric shock
The unit must be fully isolated from the mains power supply before all maintenance and cleaning work!
Risk due to electric shock, moving parts (fan) and hot surfaces .
1. Remove filter lock (see Fig. 15).
Unit type
R
AIR1 XH 1000 343
AIR1 XH 1500 378
AIR1 XH 2500 498
AIR1 XH 3500 608
AIR1 XH 4500 608
AIR1 XH 5500 883
AIR1 XH 7000 1083
AIR1 XH 8500 1228
n: Number of drill holes
Hole/screw dimensions: M8X16
Fig .14
!
11
Dimensions (mm)
S T U V W
238 315 210 – –
338 350 310 – –
338 470 310 – –
438 580 410 498 –
438 580 410 498 –
438 855 410 498 –
438 1055 410 498 361,1
438 1200 410 498 409,4
Fig .13
n
4
4
4
4
4
6
8
8
Fig .15