Flange Connection / Adapters - Helios AIR1 XH 1000-8500 Notice De Montage Et D'entretien

Installation and Operating Instructions
+
NOTE
Central ventilation units AIR1 XH
Before assembling the modules, apply gasket both surfaces of the heat exchanger module (AIR1 XH 3500, 4500, 5500,
7000, 8500), see Fig. 10.
Prior to the assembly of the modules in the final position, they must be positioned as close together as possible. Only
the respective base frame may be used to pull the modules together.
1. Pull modules close together and tighten with screw (see Fig. 11).
2. Connect the modules electrically using pre-assembled connector (see Fig. 12).

2 .1 .6 Flange connection / adapters

The dimensions for the unit flange connections can be found in the following table.
With regard to the flange connection for units AIR1 XH 3500-8500, mounting brackets must be used (mounting bra-
cket included in scope of delivery; A special mounting bracket is included in scope of delivery for certain accessories).
The ducting must be firmly and tightly connected to the connection valves.
Abb .10
Fig .10
Fig .12
10
EN