Maintenance; Cle Aning Of Surfaces (See Cleaning Instructions Manual Attached); Replacing The Remote Control Batteries; Cleaning The Whirlpool Jets - Teuco HYDROTOP Manuel De L'utilisateur

MAINTENANCE

CLEANING OF SURFACES
See CLEANING INSTRUCTIONS manual attached.
REPLACING THE REMOTE CONTROL BATTERIES
To replace the batteries of the Remote Control,
undo the four screws and remove the protective
cover.
Remove the spent batteries and replace with two
new ones, type AAA-1.5V.
Be certain to maintain the polarity as indicated
when fitting the new batteries to the remote control.
Refit the cover, taking care to position the
waterproof seal correctly.
Do not dispose of used batteries as normal refuse; place them in designated collection bins.
CLEANING THE WHIRLPOOL JETS
Remove the jet cover (5) using the included tool.
Then, with the aid of the relevant wrench (4),
dismount the jet unit (3), removing its components.
To clean the jets, use an anti-limestone, rinsing
with water.
When reassembling the jet unit (3), be careful that
the gasket (2) is firmly positioned in its seat (1).
For the jet to work properly, reassemble the ring
nut, gently tightening it (do not exert excessive
force).
Delicately re-position the cover (5) on the jet,
making sure the plaque fully locks into place all
the way to the limit stop of its centering.
OK
OK
In the event of breakdown or malfunction (e.g. system fault, problems with pump, control unit, power
unit... ) contact the nearest Teuco Authorized Service Centre (see list attached). The company will
acknowledge no liability for damage to appliances that have been tampered with.
HYDROTOP - Hydrosilence
1
2
3
4
5
NO
NO
EN
19