Regular Maintenance; Cleaning Of Surfaces (See Cleaning Instructions Manual Attached); Topping Up The Sanitizer Fluid - Teuco Hydroline Manuel De L'utilisateur

EN

REGULAR MAINTENANCE

CLEANING OF SURFACES
See CLEANING
attached.
CLEANING THE HYDRO-MASSAGE JETS
Remove the jet cover (5) using the included tool.
Then, with the aid of the relevant wrench (4),
dismount the jet unit (3), removing its components.
To clean the jets, use an anti-limestone, rinsing
with water.
When reassembling the jet unit (3), be careful that
the gasket (2) is firmly positioned in its seat (1). For
the jet to work properly, reassemble the ring nut,
gently tightening it (do not exert excessive force).
Delicately re-position the cover (5) on the jet,
making sure the plaque fully locks into place all the
way to the limit stop of its centering.

TOPPING UP THE SANITIZER FLUID

(BASIC E)
Open the filler cap for the sanitizer (1) by turning it
anticlockwise.
Pour in the sanitizer fluid.
Close the sanitizer filler cap (1) by turning it
clockwise.
14
INSTRUCTIONS
OK NO
OK NO
manual
1
2
3
4
5
1
HYDRO BASIC