Periodic Maintenance; Cleaning The Filter - Teuco S01 Manuel De L'utilisateur

The filters should be cleaned every two weeks.
Clean the filter more often if necessary.
To clean the filter:
- enter the "LOCK 30 MINUTES" function from the
control panel or disconnect the electricity supply to
the product.
- unscrew the lid (1) and remove the filter from its
seat (2).
Clean the filter with a powerful jet of water (use a
power washer if necessary).
Replace the filter as soon as it begins to show
any signs of wear.
Spare filters are available from Authorised Teuco
Dealers.
After cleaning or replacing the filter, refit all of
the parts before starting the bath tub again.
To restart the bath, disable the "BLOCK 30
MINUTES" function from the control panel.
The filter is housed inside a pressurised container.
Never open the lid or remove the filters while the system is operating.
If you are not sure about how much time you will need to clean and replace the filters then
you must absolutely disconnect the electricity to the bath, since the "LOCK 30" function from
the control panel will only stop bath operation for 30 minutes.
Fit the filters and spacer with care so as not to compromise filtering capacity.
Before switching on the tub, correctly position and block the filter housing cover. Lightly
tighten the fixing ring until the blocking mechanism on the fixing ring stops further screwing.
Clean the filter whenever the control panel reads "FLOW".
Clean the filter whenever it starts to make an unusual noise: the cartridges are clogged and
the filter is being by-passed by a special valve.
Never operate the bath when filters are blocked or have been removed, as this could
compromise the quality of the water.
S01 - S02

Periodic maintenance

CLEANING THE FILTER

1
EN
2
9