Repairs; Diagnostics Messages - Teuco HYDROTOP Manuel De L'utilisateur

EN

REPAIRS

If any part of the appliance fails to operate as it should, call the nearest Teuco Authorized Service
Centre (see list attached).
DIAGNOSTICS MESSAGES
The appliance is equipped with various safety features which monitor the operation of the system. In the
event of malfunction, a controller automatically deactivates the function currently in use. The type of error
detected is shown on the bottom line of the display. Certain kinds of trouble can be rectified without calling in
a technician; the following table indicates the action to take when a function locks up.
TROUBLE OR FAULT
ADD WATER
ADD DISINFECTANT
LOW PRESSURE
ONE OR MORE JETS
DO NOT WORK
If the display indicates a fault other than those mentioned in the table, the system needs to be RESET as
follows:
• isolate the appliance from the power supply
• reconnect power after a few seconds
• select the function which locked up previously.
If the fault persists, call the nearest Teuco Authorized Service Centre (see list attached).
20
CAUSE
Whirlpool system prevented from
starting up due to insufficient water
in tub.
Disinfection cycle prevented from
starting due to insufficient liquid in
dispenser.
Suction valve blocked.
Problems in the Cromoexperience
circuit
ACTION
Fill the tub with water to the minimum
level allowing the system to self-
activate.
Replenish the dispenser with liquid
disinfectant supplied by Teuco.
Clean the suction valve
maintenance heading).
Call the Help Centre
HYDROTOP - Hydrosilence
(see