Repairs; Diagnostics Messages - Teuco HYDROSONIC - Hydrosilence 543 Manuel De L'utilisateur

EN

REPAIRS

If any part of the appliance fails to operate as it should, call the nearest Teuco Authorized Service
Centre (see list attached).
DIAGNOSTICS MESSAGES
The appliance is equipped with various safety features which monitor the operation of the system.
In the event of malfunction, a controller automatically deactivates the function currently in use. The type of
error detected is shown on the bottom line of the display. Certain kinds of trouble can be rectified without
calling in a technician; the following table indicates the action to take when a function locks up.
TROUBLE OR FAULT
ADD WATER
ADD SANITIZER
LOW PRESSURE
ERR 39
ERR 20
ONE OR MORE JETS DO NOT
WORK
If the display indicates a fault other than those mentioned in the table, the system needs to be RESET as
follows:
• isolate the appliance from the power supply
• reconnect power after a few seconds
• select the function which locked up previously.
If the fault persist, call the nearest Teuco Aauthorized Service Centre (see list attached).
22
CAUSE
Whirlpool system prevented from
starting up due to insufficient water
in tub.
Disinfection cycle prevented from
starting due to insufficient liquid in
dispenser.
Suction valve blocked.
Product overheating.
Hydrosonic jet bosses incorrectly
positioned
Problems in the Cromo-experience
circuit.
ACTION
Fill the tub with water to the minimum
level allowing the system to self-
activate.
Replenish the dispenser with liquid
disinfectant supplied by Teuco.
Clean the suction
maintenance heading).
Make sure the product is not operating
under severe conditions (excessive
environmental temperature, direct
exposure to sunlight, proximity to
heat sources). If this is the case,
wait a few minutes for the motor/
electronics system to cool down.
Make certain the Hydrosonic jet
bosses are correctly positioned
Call the Help Centre
HYDROSONIC - Hydrosilence
valve (see