Teuco HYDROSONIC - Hydrosilence 543 Manuel De L'utilisateur page 20

EN
When the Disinfection cycle has finished, the system
shuts off and the display reverts to STAND-BY.
DISINFECTION DOES NOT START!!!
If the message "ADD WATER" is displayed, fill the
tub to the level at which the Disinfection cycle is
able to start.
DISINFECTION DOES NOT START!!!
If the message "ADD DISINFECTANT" is displayed,
replenish the dispenser with liquid so that the
Disinfection cycle is able to start.
Remove the Disinfectant dispenser cap, turning
anticlockwise.
Fill the container with Disinfectant so that the
function can start.
Replace and secure the dispenser cap.
Use only disinfectant solution supplied by Teuco.
POSTPONING THE DISINFECTION CYCLE
To postpone the disinfection cycle, press the "O/I"
button.
the system shuts off and the display reverts to
STAND-BY.
Turn the handle of the pop-up waste to empty the tub.
AUTOMATIC SHuTOFF: If there is no response within 5 seconds when the display prompts
START DISINFECTION?, the system shuts off and the display reverts to STAND-BY. DISINFECTION
of the system is not carried out.
20
STArT
DiSiNFECTioN?
Display showing
Disinfection prompt
20:30
Display in STAND-BY mode
ADD
wATEr
Display in DIAGNOSTICS mode
ADD
SANiTiZEr
Display in DIAGNOSTICS mode
20:30
Display in STAND-BY mode
HYDROSONIC - Hydrosilence