Disinfection - Teuco HYDROTOP Manuel De L'utilisateur

HEATER
Whenever the WHIRLPOOL function is activated,
the user can switch on the heater to keep the water
in the bathtub at a steady temperature.
Press the "HEATER" button to switch on.
As the heater comes on, the display will indicate its
"on" status (#) for a few seconds, then revert to the
previous item.
Press the "HEATER" button to switch off.
The heater switches off, and the display indicates
the "off" status for a few seconds before reverting
to the previous item.
AUTOMATIC SHUTOFF: When the function currently selected ceases operating, the heater will also
shut off.

DISINFECTION

When the system is switched off using the "O/I" button and after at least one whirlpooI cycle has been
selected, a DISINFECTION cycle will follow.
During Disinfection, both the remote control and the control panel are deactivated except for the "O/I"
and "ALARM" buttons, which can be used to suspend the Disinfection cycle at any given moment.
RUNNING THE DISINFECTION CYCLE
Be sure to VACATE THE BATHTUB before
Disinfection takes place.
START
DISINFECTIoN?
Display showing
Disinfection prompt
To postpone the disinfection cycle, press the "O/I" button and the display will revert to STAND-BY.
Press "ENTER" to start the Disinfection.
The display shows a warning message for a few
seconds.
Thereafter, the display indicates Disinfection in
progress.
The disinfection cycle is automatic and includes
the following steps:
• whirlpool system operates for 1 minute
approximately, with cleansing fluid supplied
from the dispenser;
• pause of 10 minutes allowing disinfectant
action;
• suction valve closes.
HYDROTOP - Hydrosilence
#
15 36 C 20:30
o
HEATER oN
Display indicating HEATER ON
15 36 C 20:30
o
HEATER oFF
Display indicating HEATER OFF
LEAVE
BATHTUB
DISINFECTIoN
RUNNING
EN
17