Scan Mode - Leica RANGEMASTER CRF 1600-B Notice D'utilisation

Scan mOde

61
72
The Leica Rangemaster CRF 1600-B can also be used for
continuous measurements (scan mode):
Hold down the main button (2) at the 2
After around 2.5 seconds, the device switches to scan
mode and then carries out continuous measurements.
This can be seen by a change in the display. Around every
1 second, a new measured value is shown.
65
Scan mode is particularly useful for measuring the range
to small or moving targets.
notes:
• In scan mode, the ABC correction value (see p. 36) is
only displayed after the last measurement.
• Because of the continuous measurements, power
consumption is greater in scan mode than for single
measurements.
31
press.
nd