Scan Mode - Leica CRF 1000-R Notice D'utilisation

Scan mOde

61
72
The Leica Rangemaster CRF 1000-R can also be used for
continuous measurements (scan mode):
Hold down the main button (2) at the 2nd press.
After around 2.5 seconds, the device switches to scan
mode and then carries out continuous measurements. This
can be seen by a change in the display. Around every 1
second, a new measured value is shown.
65
Scan mode is particularly useful for measuring the range
to small or moving targets.
notes:
• In scan mode, the
measurement.
• Because of the continuous measurements, power
consumption is greater in scan mode than for single
measurements.
25
value is displayed after the last
EHr