DeWalt DCS371 Guide D'utilisation page 15

FIG 6
FIG. 7
Installing the Brush, Brush Cap and Blade
Guards (Fig. 8)
WARNING: To reduce the risk of serious personal injury,
turn tool off and remove the battery pack before making any
adjustments or removing/installing attachments or accessories.
An accidental start-up can cause injury.
WARNING: To reduce the risk of serious personal injury, the
brush, brush cap and blade guard assembly must be installed
for one-handed use.
NOTE: It is available at extra cost from your local dealer or authorized
service center.
This assembly (brush, brush cap and blade guards) is not
compatible with the Type 1 DCS371 band saw.
F
13
1. Turn the saw over and place it on a workbench or table with the
handle to the right.
2. First, slide the brush (T) into the slot as seen in Figure 8, then place
the brush cap (U) over top and screw securely into place.
3. Install the blade guards (V) by aligning them as shown and attach
them with the hex wrench (E, Fig. 2) using the screws supplied.
Make sure they are securely attached.
FIG. 8
U
T
V V