Adjusting Trim/Speed/Steering Inputs; Finished Driving - Reely XS CoreZ Buggy 4WD RtR Mode D'emploi

c) Adjusting trim/speed/steering inputs
STEERING TRIM
1
• Use this to set the neutral point for the front wheels.
• If the car does not drive in a straight line when the steering wheel is in the middle position (hands off), slowly adjust
the dial to correct the steering.
SPEED SWITCH
2
• Use this to limit the maximum speed. The minimum setting is 40 % of the maximum speed.
STEERING REVERSE
3
• Flip the STEERING REVERSE switch if the car turns in the opposite direction to your input. Do not do this while
the car is moving!

12. Finished driving

Important
• Risk of burns! The motor, the speed controller and battery pack gets hot during operation! Do not
touch these parts immediately after operation.
• Let the vehicle cool down at least 5 to 10 minutes before inserting a new battery and driving it again.
1. Remove the car body.
2. Switch the receiver OFF.
- Press and hold the receiver power button for approximately 3 seconds.
- The LED will turn off.
3. Disconnect the battery
- Remove it for charging or before storing it.
- Fully charge the car battery before storing it.
4. Switch the transmitter OFF.
31