Getting Ready For Driving; Charge The Car Battery; Insert The Transmitter Batteries; Remove/Replace The Cover - Reely XS CoreZ Buggy 4WD RtR Mode D'emploi

10. Getting ready for driving

a) Charge the car battery
Important:
• Observe "8. Battery information and safety" on page 24".
• Only use the included charger and cable to charge the battery pack. Disconnect the battery and remove it
from the car before charging.
• USB power source: Before connecting, make sure that the USB power source can deliver sufficient
current, otherwise you may damage the source. Do not use a USB port of a computer, keyboard or USB
hub without a power adapter as the current supplied by these ports is insufficient.
Charger LED(s)
Red
Green
Blinking
b) Insert the transmitter batteries
• Open the battery compartment and insert 2x AA 1.5 V batteries, matching polarities shown inside the compartment.
• Replace the cover.
Use new batteries if the LED blinks slowly after switching it on.
c) Remove/replace the cover
• The car body is mounted onto body
posts using clips.
• Remove these to take the cover off.
28
Description
Charging
Fully charged
• Disconnect the battery/batteries and charger from the power supply.
• Replace the battery/batteries with new one(s).