List Of Materials; Tools/Materials Required; Parts Not Supplied - Elica ECP136SS Guide D'utilisation, D'entretien Et D'installation

LIST OF MATERIALS

Removing the packaging.
I CAUTION
Remove carton carefully, wear gloves to protect against sharp edges.
I WARNING
Remove the protective film covering the product before putting into operation.
Supplied Part
Hood assembly and
LED lamps already installed
5.4x75 mm screws
6.4x18 mm flat washers
Square nuts
4.2x19 mm screws

Tools/Materials required

• Level
• Drill with 1 ⁄ " (3.0 cm), ⁄ " (3.0 mm),
1 1
4 8
• Pencil
• Wire stripper or utility knife
• Tape measure or ruler
• Pliers
• Caulking gun and weatherproof caulking compound
• Vent clamps
• Saber or keyhole saw
• Metal snips
• Covered Liquid tight Flexible Metal Conduit
• Screwdrivers:
- Phillips
- Flat-blade
Parts needed
• Home power supply cable
• 1 - ½" (12.7 mm) UL listed or CSA approved strain relief
• 3 UL listed wire connectors
• 1 wall or roof cap
• Metal vent system
6
Pieces
1
14
4
9
4
Parts no supplied
Optional accessories and consumable parts
⁄ " (4.8 mm) drill bits
1
1 6
*Accessories exclusively sold in the US and Canada
Supplied Part
Round Transition 10"
(25.4cm)
Horizontal Support
10x60 mm wall anchors (concrete)
6x16 mm screws
KIT
36" (91.2 cm)
1200 CFM'S Internal
Blower Kit
1200 CFM'S External
Blower Kit*
3" Depth Spacer Kit*
KIT0153304
6" Duct Cover Kit KIT0156637
12" Duct Cover Kit
KIT0156645
Pieces
1
1
14
9
# Part
48" (121.7 cm)
KIT0156655
KIT0153054
KIT0153305
KIT0156641
KIT0156649