Electrical Connection; Complete The Installation; Description Of The Hood; Control - Elica ECP136SS Guide D'utilisation, D'entretien Et D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ELECTRICAL CONNECTION

I WARNING
ELECTRICAL SHOCK HAZARD.
I WARNING
DISCONNECT POWER BEFORE SERVICING.
REPLACE ALL PARTS AND PANELS BEFORE OPERATING.
FAILURE TO DO SO CAN RESULT IN DEATH OR ELECTRICAL
SHOCK.
NOTE: To remove the junction box cover, use an small Phillips
screwdriver (less than 15 cm tall) to fit into the hood's inner
space.
Remove the knockout and the Junction box cover and
install the conduit connector (cULus listed) in junction box.
A
B
C
D
A. White wires
B. Black wires
C. UL listed wire connector
Run 3 wires; black, white and green ,according to the
National Electrical Code and local codes and ordinances,
in
1
" conduit from service panel to junction box.
2
I WARNING
ELECTRICAL SHOCK HAZARD.
I WARNING
ELECTRICALLY GROUND BLOWER.
CONNECT GROUND WIRE TO GREEN AND YELLOW GROUND
WIRE IN TERMINAL BOX. FAILURE TO DO SO CAN RESULT IN
DEATH OR ELECTRICAL SHOCK.
Connect black wire from service panel to black or red in
junction box, white to white and green to green-yellow.
Close and secure junction box cover.
COMPLETE INSTALLATION
Replace filters.
Check operation of the hood.
If range hood does not operate:
Check that the circuit breaker is not tripped or the house
fuse blown.
Disconnect power supply. Check that wiring is correct.
To get the most efficient use from your new range hood, read
the "Maintenance" section.
Keep your Installation Instructions and Use and Care Guide
close to range hood for easy reference.
E
F
D. Green (or bare) and yellow-green
ground wire
E. Home power supply cable
F. UL listed or CSA approved ½" strain relief

DESCRIPTION OF THE HOOD

1
2
3
1.
Blower and light controls
2.
LED lamps
3.
Grease filter handle
4.
Grease filter
Controls
The range hood is designed to remove smoke, cooking vapors
and odors from the cooktop area. For best results, start the
hood before cooking and allow it to operate several minutes
after the cooking is complete to clear all smoke and odors
from the kitchen.
The hood controls are located on the center side of the hood.
Recessing Knobs
You can hide control knobs by depressing them until flush
with the hood body.
Pressing the knobs again will lower the knobs, and enable
the user to operate the lights and blower.
3
3
4
11

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ecp148ss

Table des Matières