Starting A Programme - Electrolux ESF5201LOW Notice D'utilisation

12 www.electrolux.com
A
1. Press the release button (B) to open
the lid (C).
2. Put the detergent, in powder or
tablets, in the compartment (A).
3. If the programme has a prewash
phase, put a small quantity of
detergent in the compartment (D).
4. Close the lid. Make sure that the
release button locks into position.
8.2 Using the multi-tablets
When you use tablets, that contain salt
and rinse aid, do not fill the salt container
and the rinse aid dispenser.
1. Adjust the water softener to the lowest
level.
2. Set the rinse aid dispenser to the
lowest position.
8.3 Setting and starting a
programme

Starting a programme

1. Open the water tap.
2. Close the appliance door.
3. Turn the knob until the programme
marker is aligned with the programme
you want to set.
• On/off indicator comes on.
• Start indicator starts to flash.
4. Press Start.
• The programme starts and the
• On/off indicator and start indicator
B D
30
20
indicator of the washing phase is
on.
are on.
Starting a programme with delay
start
1. Set the programme.
2. Press Delay to delay the start of the
The delay indicator comes on.
3. Press Start.
Start indicator comes on.
C
When the countdown is completed, the
programme starts.
Opening the door while the
appliance operates
If you open the door while a programme is
running, the appliance stops. When you
close the door, the appliance continues
from the point of interruption.
Cancelling the delay start while
the countdown opearates
1. Press and hold Start and Delay until
2. Press Start to start the programme.
Cancelling the programme
Press and hold Start and Delay until the
start indicator starts to flash.
Make sure that there is detergent in the
detergent dispenser before you start a
new programme.
End of the programme
When the programme is completed the
deactivate the appliance within 5 minutes
all indicators goes off. This helps to
decrease energy consumption.
1. To deactivate the appliance, turn the
2. Close the water tap.
programme of 3 hours.
the start indicator starts to flash.
indicator is on. If you do not
knob until the programme marker is
aligned with the on/off indicator.