Starting A Programme - Electrolux ESI8730RAX Notice D'utilisation

16 www.electrolux.com
5. Set and start the correct programme
for the type of load and the degree of
soil.
9.1 Using the detergent
A
CAUTION!
Only use detergent
specifically designed for
dishwashers.
1. Press the release button (A) to open
the lid (C).
2. Put the detergent, in powder or
tablets, in the compartment (B).
3. If the programme has a prewash
phase, put a small quantity of
detergent on the inner part of the
appliance door.
4. Close the lid. Make sure that the lid
locks into position.
9.2 Setting and starting a
programme
The Auto Off function
This function decreases energy
consumption by deactivating
automatically the appliance when it is not
operating.
The function comes into operation:
• 5 minutes after the completion of the
programme.
• After 5 minutes if the programme has
not started.
B
C

Starting a programme

1. Press the on/off button to activate the
appliance. Make sure that the
appliance is in programme selection
mode.
2. Press Program again and again until
the indicator of the programme you
want to select comes on.
• If you want to select the
MyFavourite programme, press
MyFavourite.
• The display shows the
programme duration.
• The door indicator is on.
3. Set the applicable options.
4. Close the appliance door.
5. Press Start to start the programme.
Only the programme bar and the
programme duration are visible in the
display
If you want to see the programme
settings, press any button except for the
on/off button. The indicators of the
running programme and options come on
for a few seconds.
Starting a programme with
delay start
1. Set a programme.
2. Press Delay again and again until
the display shows the delay time you
want to set (from 1 to 24 hours).
Only the delay time is visible in the
display.
3. Close the appliance door.
4. Press Start to start the countdown.
• The delay indicator comes on.
• When delay time is more than 10
hours, it decreases with steps of 1
hour. When delay time is less
than 10 hours, it decreases with
steps of 1 minute.
If you want to see the
programme settings, press
any button except for the
on/off button. The indicators
of the programme and
options come on for a few
seconds.
When the countdown is completed, the
programme starts.