Before First Use - Electrolux ESI8730RAX Notice D'utilisation

14 www.electrolux.com
Activating options can affect
the water and energy
consumption as well as the
programme duration.
7.1 XtraDry
Activate this option when you want to
boost the drying performance. With use
of this option, the duration of some
programmes, water consumption and the
last rinse temperature can be affected.
The XtraDry option is a permanent option
for all programmes other than
and need not to be selected at every
cycle.
Every time
option is off and needs to be chosen
manually. In other programmes, the
setting of XtraDry is permanent and it is
automatically used in next cycles. This
configuration can be changed at any
time.
Activating XtraDry option deactivates
TimeManager.
How to activate XtraDry
Press XtraDry.
The related indicator comes on.
7.2 TimeManager
This option increases the pressure and
the temperature of the water. The

8. BEFORE FIRST USE

1. Make sure that the current level of
the water softener agrees with the
hardness of the water supply. If
not, adjust the level of the water
softener.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Start a programme to remove any
processing residuals that can still be
inside the appliance. Do not use
detergent and do not put dishes in
the baskets.
is activated, XtraDry
washing and the drying phases are
shorter.
The total programme duration decreases
by approximately 50%.
The washing results are the same as
with the normal programme duration. The
drying results can decrease.
How to activate TimeManager
Press TimeManager.
The related indicator is on.
The display shows the updated
programme duration.
If the option is not applicable to the
programme:
• The programme bar is off.
• The related indicator is off or it flashes
quickly for a few seconds and then
goes out.
7.3 Hygiene
This option provides better hygiene
results by keeping the temperature at 70
°C for at least 10 minutes during the last
rinsing phase.
How to activate Hygiene
Press Option until the indicator
The display shows the updated
programme duration.
After starting the programme, the
appliance recharges the resin in the
water softener for up to 5 minutes. The
washing phase starts only after this
procedure is complete. The procedure is
repeated periodically.
8.1 The salt container
CAUTION!
Use rough salt designed for
dishwashers only. Fine salt
increases the risk of
corrosion.
is on.