Activate Or Deactivate B-Braking Stages; Acoustic Signal; Displayed Centrifugation Data After Switch-On - Hettich ROTINA 380 Mode D'emploi

EN
23

Activate or deactivate B-braking stages

The B-braking stages can be activated or deactivated as follows when the rotor is at a standstill.

Keep the key held down for 8 seconds.
PROG
After 8 seconds,  Machine Menu  appears in the display.

Press the key as often as necessary until the ->Settings is displayed.
PROG

Press the key. The SOUND / BELL = off/on is displayed.
START

Press the key as often as is required until B-Ramp = off/on is displayed.
PROG

Use the adjusting knob to set
off = B-braking stages are deactivated,
on = B-braking stages are activated.

Press the key to save the setting.
START
Briefly, Store Settings .. is displayed as confirmation, followed by -> Settings.
Press the key once to leave the "Settings" menu or press the
OPEN / STOP
"Machine Menu.
24

Acoustic signal

The acoustic signal sounds:

Upon the appearance of a disturbance in 2 second intervals.

After completion of a centrifugation run and rotor standstill in 30 second intervals.
The acoustic signal is stopped by opening the lid or pressing any key.
The signal after completion of the centrifugation run can be activated or deactivated in the following manner, if the
rotor is at standstill:

Keep the key held down for 8 seconds.
PROG
After 8 seconds,  Machine Menu  appears in the display.

Press the key as often as necessary until the ->Settings is displayed.
PROG

Press the key. The SOUND / BELL = off/on is displayed.
START

Use the adjusting knob

Press the key to save the setting.
START
Briefly, Store Settings ... is displayed as confirmation, followed by -> Settings.

Press the key once to leave the "Settings" menu or press the
OPEN / STOP
"Machine Menu".
25

Displayed centrifugation data after switch-on.

After switch-on the centrifugation data from program 1, or from the last program that was used, is displayed.
If the rotor is at standstill, this can be set as follows:

Keep the key held down for 8 seconds.
PROG
After 8 seconds,  Machine Menu  appears in the display.

Press the key as often as necessary until the ->Settings is displayed.
PROG

Press the key. The SOUND / BELL = off/on is displayed.
START

Press the key as often as necessary until Start program = Last/First is displayed.
PROG

Use the adjusting knob
Last = the program used last, First = program 1.

Press the key to save the setting.
START
Briefly, Store Settings ... is displayed as confirmation, followed by -> Settings.

Press the key once to leave the "Settings" menu or press the
OPEN / STOP
"Machine Menu".
60/165
off or on.
to set off or on.
to set Last or First.
key twice to leave the
OPEN / STOP
key twice to leave the
OPEN / STOP
key twice to leave the
OPEN / STOP