Hettich ROTINA 380 Mode D'emploi page 70

EN
Message / fault
SENSOR-ERROR
SENSOR-ERROR 91 - 93
NO ROTOR OR
ROTORCODE
ERROR
WRONG ROTOR !!!
N  ROTOR MAX
N > ROTOR MAX
in Prog : e.g. 3
Runtime 00:00
in Prog : e.g. 3
Empty Program
FC INIT ERROR
FC VERSION ERROR
FATAL EEPROM 1 - 5
ERROR
70/165
Cause
90 Error / defect electronics
Error / defect unbalance sensor
No rotor installed.
Faulty speedometer.
(for type 1701-30 only)
A rotor is installed which isn't approved for
type 1701-30.
Speed in the selected program greater than
the maximum speed of the rotor.
The rotor has been changed. The
maximum speed of the installed rotor is
higher than that of the rotor that was
previously used and this has not yet been
detected by rotor recognition.
There is a program in the displayed
program location whose speed is higher
than the maximum speed of the rotor.
The rotor has been changed. The
maximum speed of the installed rotor is
higher than that of the rotor that was
previously used and this has not yet been
detected by rotor recognition.
There is a continuous operation program in
the displayed program location.
There is no program linkage saved on the
displayed program location.
Error / defect electronics
Error / defect electronics
Error / defect electronics
Remedy
 Perform a MAINS RESET.
 Open lid.
 Install rotor.
 Open lid.
 Install rotor 1798.
 Check the set speed.
Reduce the set speed
 Set a speed up to the maximum
speed of the rotor that was
previously used. Press the
key to run rotor
START
recognition. See chapter, "Rotor
Recognition".
 Check the set speed.
Reduce the set speed
 Set a speed up to the maximum
speed of the rotor that was
previously used. Press the
key to run rotor
START
recognition. See chapter, "Rotor
Recognition".
 Replace the continuous operation
program in the program linkage
with a program with preset time.
 Call up a program linkage.
 Perform a MAINS RESET.