Technical Data - EINHELL 41.386.70 Instructions D'utilisation Et D'entretien

Anleitung DWS 90 13.11.2001 7:30 Uhr
Dear Customer,
Before you use the universal sander/grinder for the
first time, please read these instructions and note the
information for the tool's operation and maintenance.
Always keep this manual with the tool.
1. Items supplied
1 universal drive
1 drill chuck Ø 1.5 - 10 mm
1 plug-in nipple R 1/4"
1 drill chuck key
grinding pin holder Ø 6 mm
socket wrench 3 mm
2 fork wrenches size 11/17 mm
1 belt file
2 sanding belts 330 x 10 mm

2. Technical data

Permissible working pressure max.
Air consumption
Recommended hose diameter internal
Speed
Air quality
cleaned and oiled, via conditioning unit with filter
pressure reducer and mist oiler
Compressor capacity
approx. 250 l/min. equivalent to a motor
rating of 2.2 kW
Work settings
6 bar working pressure set at the pressure
reducer or filter pressure reducer
Please note:
When working with the universal sander/grinder,
be sure to wear the necessary protective
clothing, particularly goggles and safety gloves.
Observe the safety regulations.
Seite 5
3. Illustration
A belt sander
B pin grinder
6 bar
approx. 170 l/min.
Ø 9 mm
20000 min -1
C drill
4. Proper use
The universal sander/grinder is a pneumatic tool for
universal service. It is suitable e.g. for use in
workshops, DIY, hobbies and automotive bodywork
departments.
The exhaust air leaves the tool to the front.
Repairs and maintenance work are to be carried out
only by authorized specialist workshops.
Please note!
The power of the tool will be reduced if you use a
hose that has too small an inner diameter or
which is too long.
GB
5