Technical Data - EINHELL Bavaria BOFT 800 Mode D'emploi

Anleitung BOFT 800 SPK1
31. Never cut over metal parts, screws, nails etc.
32. To avoid damage to the router, make sure there
are no foreign objects attached to the workpiece.
Please refer to the booklet included in delivery
for further safety instructions.
3. Layout (Fig. 1/2/3)
1. Longitudinal stop
2. Table width extension
3. Feet
4. Table top
5. Workpiece guides
6. ON/OFF switch
7. Angle stop
8. Transparent router cover
9. Connection for dust extractor
10. Table insert
11. Installation material for feet and table width
extension
12. Installation material for router
13. Installation material for workpiece guides
14. Installation material for longitudinal stop
15. Clip for routers without continuous operation
mode
Important! There is no router supplied with the
router table!
4. Assembly
See Fig. 3 to 12 for assembly instructions
5. Starting up
5.1 ON/OFF switch (6)
To turn the machine on, press the green button.
To turn the machine off again, press the red
button.
5.2 Dust extractor (9)
Important! For health safety reasons it is imperative
that you use a dust extractor. You can connect a
dust extractor to the vacuum extractor unit adaptor
(9).
5.3 Working with the router table (Fig. 12/13/14)
Insert the routing cutters into the router, then set
the speed and routing depth. Refer to the
10.03.2006 10:57 Uhr Seite 11
operating instructions of the router.
Insert a suitable table insert into the router table.
Select the table insert (10) so that the distance
between the router and table insert is as small as
possible. The router, however, must be able to
turn unhindered.
Adjust the workpiece guides (5) in accordance
with the dimensions of the workpiece.
Set the ON/OFF switch of the router to
continuous operation.
Connect the connector cable of the router to the
switch (6).
Connect the switch of the router table to the
power supply with a suitable extension cable
Turn on the router table with the switch (6).
After each adjustment it is imperative to carry out
a test cut on a piece of scrap wood and readjust
the workpiece guides if necessary.
Push the workpiece along the workpiece guides
(5) and past the routing head in the direction of
the spring disks.
Exert only little thrust on the workpiece.
Use a push stick in case of small workpieces.
Important! Pull out the power plug before
performing any cleaning, adjusting and
maintenance work. Also, pull out the power plug
when you have finished working.
5.4 Router without continuous operation mode
(Fig. 8)
If your router is not equipped with a continuous
operation mode you can use the supplied clip (15) to
lock the switch.
Important! Use the clip (15) only if the router is
operated by way of the switch (6).

6. Technical data

Mains connection:
Table height:
Table size:
Table size with width extension:
Max. cutter Ø:
GB
230V ~ 50 Hz
280mm
335 x 450mm
335 x 860mm
39mm
11