Maintenance And Cleaning - EINHELL 41.386.70 Instructions D'utilisation Et D'entretien

Anleitung DWS 90 13.11.2001 7:30 Uhr
Drill chuck
To fit the drill chuck you must first remove the
grinding pin holder or the belt sander attachment with
guide roll. Screw the drill chuck on the tool and
tighten securely with the supplied wrenches.
drill
Grinding pin holder
To fit the grinding pin holder you must first remove
the drill chuck or the belt sander attachment with
guide roll. Screw the grinding pin holder on the tool
and tighten securely with the wrenches.
pin grinder

7. Maintenance and cleaning

Observance of the following maintenance
instructions will ensure that this quality tool gives you
years of troublefree service.
Regular lubrication is vital for the long-term, reliable
operation of your universal sander/grinder. Use only
special tool oil for this purpose.
You can choose from the following options for
lubricating the tool:
Seite 7
7.1 By mist oiler
A complete conditioning unit includes a mist oiler and
is fitted to the compressor.
7.2 By hand
Each time before you use your universal
sander/grinder, feed 3-5 drops of special tool oil into
the air connection. If the pneumatic tool has not been
used for several days, you must feed 5-10 drops of
oil into the air connection before you switch on.
Keep your pneumatic tool in dry rooms only.
The warranty does not cover:
Wearing parts
Damage caused by an unacceptable level of
working pressure.
Damage caused by unconditioned compressed
air.
Damage caused by improper use or unauthorized
tam
GB
7