Intended Use - DeWalt DWE4517 Guide D'utilisation

H
FIG. 1
F
B
C
G
COMPONENTS (FIG. 1)
WARNING: Never modify the power tool or any part of it. Damage
or personal injury could result.
A. Trigger switch
B. Spindle lock button
C. Side handle
D. Spindle

INTENDED USE

This grinder is designed for professional grinding, sanding, wire
brushing, polishing or abrasive, cutting-off applications.
DO NOT use under wet conditions or in presence of flammable
liquids or gases.
This grinder is a professional power tool. DO NOT let children come
into contact with the tool. Supervision is required when inexperienced
operators use this tool.
D
E
A
E. Soft mount
F. Trigger lock off button
G. Wheel guard
H. Lock-on button
Features
SWITCH (FIG. 1)
This tool is controlled by a trigger switch (A). A lock-on button (H)
provides increased comfort in extended use applications.
ROTATING GEAR CASE
For applications in which a tool will be dedicated for uses in edge
grinding and finishing work, the gear case may be rotated 90° left or
right of its original position. See page 9 for instructions on rotating
the gear case.
SPINDLE LOCK (FIG. 2)
The spindle lock pin is provided to prevent the
spindle from rotating when installing or
removing wheels. Operate the spindle lock pin
only when the tool is turned off and unplugged
from the power source. To engage the lock,
depress the spindle lock button (B) and rotate
the spindle until you are unable to rotate it
further.
CAUTION: Never depress the spindle lock button while the grinder
is running. Never turn on the grinder while the spindle lock button is
depressed. Damage to your tool or personal injury may result.
SOFT MOUNT
The grinder is equipped with a soft mount, enabling easy wheel
installation and removal.
Accessories and Attachments
It is important to choose the correct guards, backing pads
and flanges to use with grinder accessories. See the chart on
pages 11–13 for information on choosing the correct accessories.
WARNING: Accessories must be rated for at least the speed
recom mended on the tool warning label. Wheels and other
8
B
FIG. 2