Wiring Connection - Kenwood KDC-BT710DAB Mode D'emploi

INSTALLATION/CONNECTION

Wiring connection

Front/Rear/Subwoofer output
For 3-way crossover:
Mid Range/Woofer output
Connecting the ISO connectors on some VW/Audi or Opel
(Vauxhall) automobiles
You may need to modify the wiring of the supplied wiring harness as
illustrated below.
A7 (Red)
Vehicle
A4 (Yellow)
Default wiring
Pin Color and function (for ISO connectors)
: Battery
A4 Yellow
Blue/White *
1 : Power control
A5
: Ignition (ACC)
A7 Red
A8 Black : Earth (ground) connection
Purple ]
B1
: Rear speaker (right)
For 3-way crossover: Tweeter (right)
Purple/black [
B2
Gray ]
B3
: Front speaker (right)
For 3-way crossover: Mid range speaker (right)
Gray/black [
B4
B5 White ]
: Front speaker (left)
White/black [ For 3-way crossover: Mid range speaker (left)
B6
Green ]
B7
: Rear speaker (left)
For 3-way crossover: Tweeter (left)
Green/black [
B8
Antenna
terminal
Microphone input jack ( 12)
DAB antenna
jack ( 5)
Yellow (Battery wire)
Ignition wire (Red)
Unit
Red (Ignition wire)
Battery wire (Yellow)
ISO connectors
Fuse (10 A)
If no connections are made, do not let the wire come out
Light blue/yellow
(Steering remote
control wire)
Red (A7)
Blue/White *
2
(Power control wire/
Antenna control wire)
Yellow (A4)
Brown
(Mute control wire)
If your car does not have an ISO terminal:
We recommend installing the unit with a commercially
available custom wiring harness specific for your car and
leave this job to professionals for your safety. Consult your
car audio dealer.
When connecting to an external amplifier, connect its
ground wire to the car's chassis to avoid damaging the unit.
from the tab.
STEERING WHEEL
REMOTE INPUT To the steering wheel
remote control adapter
REMOTE CONT
To the power control terminal
ANT CONT
when using the optional power
P. CONT
amplifier or to the antenna control
terminal in the vehicle
To connect the Kenwood
navigation system, refer your
MUTE
navigation manual
NOTE: Total output for Blue/White wire ( *
is 12 V 350 mA.
1 ) + ( * 2
)
31
ENGLISH