Installing The Dab Antenna - Kenwood KDC-BT710DAB Mode D'emploi

INSTALLATION/CONNECTION

Installing the DAB antenna

Connect the supplied DAB antenna to the DAB antenna jack. ( 31)
Caution
• The film antenna (F) is exclusively for use inside the vehicle.
• Do not install at the following locations:
– where it may block the driver's view.
– where it may obstruct the operation of safety devices such as air
bags.
– on movable glass surfaces such as the rear hatch.
– at side of vehicle (e.g. door, front quarter window).
– on rear window.
• Signal strength will weaken when installed at the following
locations:
– on IR reflecting glass or locations covered with mirror type glass
film.
– where it overlaps with genuine radio antenna (pattern).
– where it overlaps with window heating wires.
– on glass that blocks radio signals (e.g. IR reflecting glass, thermal
insulation glass).
• Poor reception may occur:
– due to noise when windscreen wiper, air conditioner, or motor is
turned on.
– depending on the direction of the broadcast station with respect
to the vehicle (antenna).
• Thoroughly wipe oil and dirt from the pasting surface with the
supplied cleaner (I).
• Do not bend or damage the film antenna (F).
• It may not be possible to install on certain vehicles.
• Check the cable routing of the film antenna (F) and amplifier unit
(G) before pasting.
• Do not apply any glass cleaner after pasting the film antenna (F).
32
ENGLISH
Determine the antenna installation position
• The direction of the film antenna (F) changes depending on whether the film antenna (F) is installed on the
right side or left side.
• Be sure to check the installation location of film antenna (F) before installing. Film antenna cannot be re-pasted.
• Separate from other antennas by at least 100 mm.
• Do not paste the amplifier unit (G) on the ceramic line (black part) around the front glass. Because there is not
enough adhesion.
Installing the antenna on the left side
(F)
(G)
Earth sheet*
* Paste the earth sheet of the amplifier unit (G) on the metal part of the front pillar.
Part list for installation
(F) Film antenna
Installing the antenna on the right side
Ceramic line (black part)
(G)
(G) Amplifier unit
(cable with booster, 3.5 m)
Earth sheet*
(F)
(H) Cable clamper
(I) Cleaner