Troubleshooting - Kenwood KDC-BT710DAB Mode D'emploi

DISPLAY SETTINGS
DISPLAY
COLOR Select color for ALL ZONE, ZONE 1 and ZONE 2 separately.
SELECT
1 Select a zone. (See the illustration on page 22.)
2 Select a color for the selected zone.
VARIABLE SCAN/CUSTOM R/G/B/preset colors*
To make your own color, select [CUSTOM R/G/B]. The color you have made
will be stored in [CUSTOM R/G/B].
1 Press the volume knob to enter the detailed color adjustment.
2 Press S / T to select the color (R/G/B) to adjust.
3 Turn the volume knob to adjust the level (0 to 9), then press the knob.
DIMMER Dim the illumination.
ON: Dimmer is turned on. ; OFF: Cancels.
DIMMER TIME: Set the dimmer on and off time.
1 Turn the volume knob to adjust the [ON] time, then press the knob.
2 Turn the volume knob to adjust the [OFF] time, then press the knob.
(Default: [ON]: 18:00; [OFF]: 6:00)
BRIGHTNESS 1 Select a zone. (See the illustration on page 22.)
2 0 to 31: Select your preferred brightness level for the selected zone.
TEXT SCROLL AUTO/ONCE: Select whether to scroll the display information automatically,
or scroll only once. ; OFF: Cancels.
* Preset colors: RED1/RED2/RED3/PURPLE1/PURPLE2/PURPLE3/PURPLE4/BLUE1/
BLUE2/BLUE3/SKYBLUE1/SKYBLUE2/LIGHTBLUE/AQUA1/AQUA2/GREEN1/
GREEN2/GREEN3/YELLOWGREEN1/YELLOWGREEN2/YELLOW/ORANGE1/ORANGE2/
ORANGERED

TROUBLESHOOTING

Default: XX
Symptom
Sound cannot be heard.
"MISWIRING CHECK WIRING
THEN PWR ON" appears.
"PROTECTING SEND SERVICE"
appears.
• Sound cannot be heard.
• The unit does not turn on.
• Information shown on the
display is incorrect.
The unit does not work at all.
DAB reception is poor.
"DAB ANT ERR"
"RELATED SERV FOUND"
• Radio reception is poor.
• Static noise while listening
to the radio.
Remedy
• Adjust the volume to the optimum level.
• Check the cords and connections.
Turn the power off, then check to be sure the
terminals of the speaker wires are insulated
properly. Turn the power on again.
Send the unit to the nearest service center.
Clean the connectors. ( 26)
Reset the unit. ( 3)
Make sure [ON] is selected for [DAB ANT POWER].
( 4)
Check the DAB antenna. If a passive antenna
(without a booster) is used, set [DAB ANT POWER]
to [OFF]. ( 4)
• Press the volume knob to activate Soft-Link.
( 7)
• Press to cancel.
Connect the antenna firmly.
ENGLISH
23