Troubleshooting - Kenwood KDC-BT39DAB Mode D'emploi

MORE INFORMATION
About iPod/iPhone
Made for
- iPod touch (2nd, 3rd, 4th, and 5th generation)
- iPod classic
- iPod nano (3rd, 4th, 5th, 6th, and 7th generation)
- iPhone 3G, 3GS, 4, 4S, 5, 5S, 5C
• For the latest compatible list and software versions of iPhone/iPod, see:
www.kenwood.com/cs/ce/ipod
• You cannot operate iPod if "KENWOOD" or " " is displayed on iPod.
About Android device
• This unit supports Android OS 4.1 and above.
• Some Android devices (with OS 4.1 and above) may not fully support Android Open Accessory
(AOA) 2.0.
• If the Android device supports both mass storage class device and AOA 2.0, this unit always
playback via AOA 2.0 as priority.
• For more information and the latest compatible list, see: www.kenwood.com/cs/ce/
About Bluetooth
• Depending on the Bluetooth version of the device, some Bluetooth devices may not be able
to connect to this unit.
• This unit may not work with some Bluetooth devices.
• Signal conditions vary, depending on the surroundings.
• For more information about Bluetooth, visit the following website:
www.kenwood.com/cs/ce/
(For )
Muting upon the reception of a phone call
Connect the MUTE wire to your telephone using a commercial
telephone accessory. ( 24)
When a call comes in, "CALL" appears. (The audio system pauses.)
• To continue listening to the audio system during a call, press
"CALL" disappears and the audio system resumes.
When the call ends, "CALL" disappears. (The audio system resumes.)

TROUBLESHOOTING

Symptom
Sound cannot be heard.
"MISWIRING CHECK WIRING
THEN PWR ON" appears.
"PROTECTING SEND SERVICE"
appears.
• Sound cannot be heard.
• The unit does not turn on.
• Information shown on the
display is incorrect.
The unit does not work at all.
DAB reception is poor.
"DAB ANT ERR"
"RELATED SERV FOUND"
• Radio reception is poor.
• Static noise while listening
to the radio.
Disc cannot be ejected.
.
Noise is generated.
Tracks do not play back as you
intended them to play.
Remedy
• Adjust the volume to the optimum level.
• Check the cords and connections.
Turn the power off, then check to be sure the
terminals of the speaker wires are insulated
properly. Turn the power on again.
Send the unit to the nearest service center.
Clean the connectors. ( 2)
Reset the unit. ( 3)
Make sure [ON] is selected for [DAB ANT POWER].
( 5)
Check the DAB antenna. If a passive antenna
(without a booster) is used, set [DAB ANT POWER]
to [OFF]. ( 5)
• Press the volume knob to activate Soft-Link. ( 7)
• Press
to cancel.
• Connect the antenna firmly.
• Pull the antenna out all the way.
Press and hold M to forcibly eject the disc. Be careful
not to drop the disc when it is ejected. If this does
not solve the problem, reset the unit. ( 3)
Skip to another track or change the disc.
Playback order is determined when files are
recorded.
ENGLISH
19