Wiring Connection - Kenwood KDC-DAB400U Mode D'emploi

INSTALLATION / CONNECTION

Wiring connection

DAB antenna jack ( 5)
Connecting the ISO connectors on some VW/Audi or
Opel (Vauxhall) automobiles
You may need to modify the wiring of the supplied wiring
harness as illustrated below.
A7 (Red)
Vehicle
A4 (Yellow)
Default wiring
Pin Color and function
A4 Yellow : Battery
A5 Blue/White : Power control
A7 Red : Ignition (ACC)
A8 Black : Earth (ground) connection
B1 Purple ]
: Rear speaker (right)
Purple/black [
B2
Gray ]
B3
: Front speaker (right)
Gray/black [
B4
White ]
B5
: Front speaker (left)
B6 White/black [
Green ]
B7
: Rear speaker (left)
Green/black [
B8
20
Antenna terminal Front/ Rear/ Subwoofer output
Yellow (Battery wire)
Ignition wire
(Red)
Unit
Battery wire
(Yellow)
ISO connectors
Fuse (10 A)
If no connections are made, do not let the wire come out from the tab.
Red (Ignition wire) Light blue/yellow
(Steering remote control
wire)
Red (A7)
Blue/White
(Power control wire/
Antenna control wire)
Yellow (A4)
Brown
(Mute control wire)
If your car does not have an ISO terminal :
We recommend installing the unit with a commercially available
custom wiring harness specific for your car and leave this job to
professionals for your safety. Consult your car audio dealer.
When connecting to an external amplifier, connect its ground
wire to the car's chassis to avoid damaging the unit.
STEERING WHEEL
REMOTE INPUT To the steering wheel remote control
adapter
REMOTE CONT
To the power control terminal when
ANT CONT
using the optional power amplifier
or to the antenna control terminal in
P. CONT
the vehicle
To the terminal that is grounded
when the telephone rings or during
conversation ( 15)
MUTE
(To connect the Kenwood navigation
system, refer your navigations manual.)