Kenwood KDC-DAB400U Mode D'emploi page 21

INSTALLATION / CONNECTION
Installing the unit (in-dash mounting)
Orientate the trim plate as
illustrated before fitting.
How to remove the unit
1 Detach the faceplate.
2 Fit the catch pin on the extraction keys into the holes
on both sides of the trim plate, then pull it out.
3
Insert the extraction keys deeply into the slots on
each side, then follow the arrows as shown on the
right.
Do the required wiring.
( 20)
Hook on the top side
Bend the appropriate tabs to hold the
mounting sleeve firmly in place.
Part list for installation
(A) Faceplate
(B) Trim plate
Dashboard of your car
(C) Mounting sleeve
(D) Wiring harness
(E) Extraction key
19
ENGLISH