CareFusion MicroLoop Manuel D'utilisation page 88

IMPORTANT: Only use the mains adapter supplied (36-PSU1013 5V
DC 2.0A) The adapter contains a transformer. Do not cut off the
adapter to replace it with another plug as this causes a hazardous
situation. Turn off the mains supply or remove the MicroLoop from
the charger once the battery display shows fully charged.
 The adapter transforms the mains voltage (100-240 Volts) to a
safe voltage (5V DC)
 Make sure the adapter does not get wet
 Do not use a damaged adapter
 Always unplug your MicroLoop before cleaning
WARNING: Do not connect devices that are not specified as part of
the system.
Note: If an MPSO (Multiple Portable Socket Outlet) is used with the
system, the maximum permitted load should not be exceeded. Do
not connect electrical equipment that has not been supplied as part
of the system.
WARNING: To avoid risk of electric shock, this equipment must
only be connected to supply mains with protective earth.
86