Printing; Switching Off; Charging Procedure - CareFusion MicroLoop Manuel D'utilisation

Printing

Using the cables provided connect the mini USB A/B socket on the
back of MicroLoop cradle to the input socket on the printer. For a list
of compatible printers refer to the web site or contact your local
dealer
It is recommended that during printing the batteries are placed on
charge with the cradle connected to the mains adapter.
Note: Keep the printer out of reach of the patient at all times.
Note: Disconnect the printer during live measurements.
CAUTION: Connect the MicroLoop only to printers and computers
that comply with EN 60601-1 – 'Information technology equipment -
Safety - Part 1: General requirements'.

Switching Off

The unit is switched off by pressing the On/Off button.
The unit can be disconnected from the mains by unplugging the
charger from the mains socket or unplugging the USB cable.

Charging Procedure

The MicroLoop's internal batteries are discharged when shipped from
the factory and should be fully charged on first use. Plug the AC
adapter into the mains supply and plug the adapter output plug into
the power input socket on the cradle. The orange charging light on
top of the unit will flash to indicate charging and will turn on
constantly to indicate full charge. The blue lights on the cradle will
also be illuminated.
The batteries will take approximately 4 hours to become fully
charged.
30