CareFusion MicroLoop Manuel D'utilisation page 44

Voltage dips,
short
interruptions
and voltage
variations on
power supply
input lines
IEC61000-4-11
Power
frequency
(50/60Hz)
Magnetic field
IEC61000-4-8
NOTE U is the a.c. mains voltage prior to application of the test level.
T
Guidance and Manufacturer's Declaration – Electromagnetic Immunity
The MicroLoop is intended for use in the electromagnetic environment specified
below. The customer or the user of the MicroLoop should assure that it is used in such
an environment.
Immunity
Test
Conducted RF 3 Vrms
IEC61000-4-6 150 kHz to
<5% U
T
(>95 % dip in U
T
For 0.5 cycle
40% U
T
(60 % dip in U )
T
for 5 cycles
70 % U
T
(30 % dip in U )
T
for 25 cycles
<5% U
T
(>95 % dip in U
T
For 5 s
3 A/m
IEC 60601 Compliance
test level Level
<5% U
T
) (>95 % dip in U
For 0.5 cycle
40% U
T
(60 % dip in U
for 5 cycles
70 % U
T
(30 % dip in U
for 25 cycles
<5% U
T
) (>95 % dip in U
For 5 s
3 A/m
Electromagnetic Enviroment -
Guidance
Portable and mobile RF
communications equipment should
be used no closer to any part of the
MicroLoop, including any cables, than
the recommended separation
distance calculated from the equation
applicable to the frequency of the
transmitter.
Recommended separation
distance (d)
3 Vrms d = 1.2√P
42
Mains power quality
) should be that of a
T
typical commercial or
hospital environment. If
) the user of the
T
MicroLoop requires
continued operation
) during power mains
T
interruptions, it is
recommended that the
) MicroLoop be powered
T
from an uninterruptable
power supply or a
battery
If incorrect operation
occurs, it may be
necessary to position the
MicroLoop further from
sources of power
frequency magnetic
fields or to install
magnetic shielding. The
power frequency
magnetic field should be
measured in the
intended installation
location to assure that it
is sufficiently low.