Additional Functions - geo-FENNEL Multi-Digit Pro + Mode D'emploi

EN

ADDITIONAL FUNCTIONS

Automatic shut-off
If no button is used for 20 min. the instrument will switch off automatically.
Sound
Switch the sound function on. The instrument will now show by a sound signal if the horizontal or
vertical position approaches. The closer the position is the denser the sound signal will be.
If the instrument is in correct vertical or horizontal position the sound will be continuous.
Mode functions [1) - 5)]
1) Slope indication in ° (14,5°)
2) Slope indicaton in % (25,9 %)
3) Indication IN/FT (3 1/8 IN/FT)
4) Indication IN/FT (3,10 IN/FT)
5) Indication mm/m (258,9 mm/m)
Keep the mode button pressed to have all mode functions switch fast. The display will not show any
values. Release the mode button to return to standard indication.
CONNECTION TO CAMERA TRIPOD
With the 1/4" thread (at the bottom side) Multi-Digit pro + can be connected to a camera tripod.
D
CHECK AND CALIBRATION
MPORTANT
Calibration of inclinometer:
- before first use
- before important measurements
- after a hit or drop
- after a large fluctuation in temperature
CHECK OF SLOPE MEASUREMENT
Set the instrument down on a flat and even surface and switch it on. Wait until the display indication
appears and note down the measured value (A).
Turn the unit by 180° and set it down on the same position as before. Wait until the display indication
appears and note down the measured value (B).
If the deviation between the two values A and B is more than 0,2° the unit has to be calibrated.
13