Nice F210S Instructions Et Avertissements Pour L'installation Et L'utilisation page 5

3.3.1) Typical connection example (complete)
Figure 9 shows a complete connection example of the F210S device with the use of a pressure sensitive device and 3 inde-
pendent buttons for the opening, closing and stop of the automation.
9
3.3.2) Connection example with Step-by-Step control
If a Step-by-Step (open-stop-close-stop) control of the automation is sufficient, the connection shown in figure 10 can be
made, placing the OPEN and CLOSE inputs in parallel.
!
Maintain the 8.2KΩ resistance on the sensitive edge input.
10
3.3.3) Connection of 2 or more sensitive edges
The F210S receiver has only one sensitive edge input, but 2 or more sensitive edges that perform the same function can be
cascade connected one after the other as in figure 11 applying a single 8.2KΩ termination resistance.
!
The constant resistance devices must be cascade connected and never in series or parallel to one another!
11
STEP BY STEP
GB
5