Preliminary Checks - Nice F210S Instructions Et Avertissements Pour L'installation Et L'utilisation

Because the F210S photocells have a horizontal scope of 210° and a vertical scope of 30°, they can also be applied on uneven
surfaces where the correct alignment between TX and RX is not normally possible (see fig. 2a, 2b and 2c). An additional "van-
dal-proof" metal container is also available code FA1.
2a
3) Installation
!
The system must be disconnected from the mains power supply during installation.

3.1) Preliminary checks

Due to the peculiarity and uniqueness of the product, certain aspects concerning the operating principles must be evaluated
before proceeding with the installation in order to ensure maximum safety and functionality.
• Make sure that the F210S photocell can be used on the motor or control unit to which it is to be connected. If in doubt, con-
tact the Nice technical assistance for clarification.
• Only one pair of F210S photocells can be used for each motor or control unit, never connect more than one pair of F210S
photocells in parallel.
• The F210S photocells use a "synchronising" system so that they are not disturbed by other similar devices in the vicinity.
• Before connecting the F210S photocells, program the motor or control unit introducing possible remote control devices
• The F210S TX transmitter emits a beam with an angle of approximately ±4°, therefore a perfect alignment between TX and
RX is necessary.
3.2) Fixing of the devices
Perform the fixing of the devices following the operations below:
1. Depending on the type of installation, the cable can be introduced from the base (se figure 3) or from the lower side. In this
case a "PG9" cable connector will be required (see figure 4).
2. To make fixing easier, the electronic board can be separated from the base, using a screwdriver to lever the three clips as
indicated in fig. 5.
3
2b
4
2c
5
GB
3