Cancelling The Post-Drying Program (Only Pro D3/Prod3I); Switching Off Functions; Deactivating The Control Panel; Switching Off The Power Supply Unit - Harvia SENTIO Professional D Série Instructions D'installation Et Mode D'emploi

Instructions for use for the user

10.20. Cancelling the post-drying program (only Pro D3/ProD3i)

After the combi-mode, the post-drying program is started automatically. This in-
volves heating the sauna room to 80 °C with the fan running for 30 minutes.
In the display 1, the text "dry" is displayed and the temperature symbol flashes.
● Press the On/Off button A for about 3 seconds to cancel the post-drying
program.
To prevent mould and rot from forming, the post-drying program should
NOT be cancelled.

10.21. Switching off functions

You can switch off each function individually.
1. Select the function you wish to switch off by pressing the mode button D.
2. Press the On/Off button A.
► The function concerned is switched off.
► The display 1 shows "oFF".
If you switch off the sauna heater (temperature function A), the evapora-
tor (humidity function B) is automatically switched off.

10.22. Deactivating the control panel

● Press the On/Off button A for about 3 seconds.
► The display 1 shows "---".
► The sauna control unit is in standby mode.

10.23. Switching off the power supply unit

If you will not be using the sauna control unit for an extended period of time,
switch the sauna control unit off at the power supply unit.
● Press the On/Off button F.
► The display 1 goes out.
► The sauna control unit is switched off.
p. 60/70