Starting Additional Output (Only Pro D2I/Pro D3I) - Harvia SENTIO Professional D Série Instructions D'installation Et Mode D'emploi

Instructions for use for the user
The evaporator (humidity function 6) can only be started when the
sauna heater (temperature function 5) is switched on. The maximum
humidity level which can be set depends on the temperature of the sauna.
The higher the sauna temperature, the lower the maximum humidity level
which can be set.
Exception: Evaporator single mode is activated (see "Activating evapora-
tor single mode (only Pro D3/Pro D3i)" on page 39). The evaporator
can also be operated here without the sauna heater, with the maximum
humidity depending on the current sauna room temperature.

10.9. Starting additional output (only Pro D2i/Pro D3i)

Infrared lamps, or infra-red heater panels, for example, can be connected to the
additional output on the sauna control unit.
WARNING!
Risk of fire
Combustible objects that are placed on or in front of the infra-red lamp
could ignite and cause fires.
● NEVER place combustible objects on or in front of the infra-red lamp.
● Make sure that NO combustible objects have been placed on or in
front of the infra-red lamp before you switch it on.
Two different modes are available for the additional output:
1. Intensity regulation
2. Room temperature regulation
To change the mode see: "Setting mode of the additional output (only Pro
D2i/Pro D3i)" on page 43
p. 52/70