Control Panel - Rane Seventy-two Guide D'utilisation

Faders
Seventy-Two's Channel Faders and Crossfader are contactless MAG THREE faders with
adjustable tension.
To adjust the tension on Seventy-Two's faders:
1. Make sure the unit is powered off and
disconnected from a power source.
2. Using a screwdriver, remove the screws from
faceplate at bottom of the top panel where the
faders are located (see image).
Note: The fader caps must be removed to
remove the faceplate.
3. Using a screwdriver, adjust the tension screw for
each fader to your preference.

Control Panel

The Rane Control Panel allows you to adjust settings
on your Seventy-Two mixer and save and load these
settings to a file (.r72) on your computer. Using
settings files lets you maintain several different control
configurations to use in different situations.
To manage settings files, navigate to the Settings
section of the Rane Control Panel, under the General
tab.
•
Load: Select this to locate and load a Seventy-
Two settings file (.r72) on your computer to the
Control Panel.
•
Save: Select this to save the mixer's settings to
your computer as a Seventy-Two settings file
(.r72).
22
Top Panel Fader Plate
MAG THREE Fader
Top View
Tension Screw