Rane Seventy-two Guide D'utilisation page 14

Touch FX
Press the Touch FX button to open the Touch FX screen, where you can simply touch the display to
activate and manipulate the effects on Deck 1 or 2.
To select which deck the Touch FX is applied to, tap the respective Deck arrow. The FX buttons
for the effects routed to that deck will be highlighted.
To activate and manipulate effects routed to the deck, slide your finger across the display.
Sliding on the Y-axis applies a high pass (up) or low pass (down) Filter. Sliding on the X-axis
changes the Time parameter for any active Flex FX. The Time parameter for the Flex FX will be
displayed at the bottom of the Touch FX screen and will update as you slide left/right on the X-axis.
Upon releasing your finger from the Touchscreen, the filter will be deactivated and the FX timing will
return to its previous setting. You can change the default Time parameter from the Touch FX screen
by tapping it and turning the Parameter Knob.
Note: For the Beat Breaker and Reverb Flex FX, the displayed parameter is not time but pattern
number and decay percentage respectively.
Note: Beat Breaker editing can be entered from the Touch FX screen by tapping the pattern number
and then pressing Shift and the Parameter Knob. See Effects > Effects View above to learn
more.
To change the Flex effect activated on the deck, tap the name of the effect, press Parameter
Knob to enter FX select mode, and then turn the Parameter Knob to cycle through effects. Press
the Parameter Knob again to exit FX select mode.
14