Rane Seventy-two Guide D'utilisation page 21

Slicer Loop
Hold Shift and press Slicer / Transport (5) to enter Slicer Loop mode. The pads behave
identically to the pads in Slicer Mode, except the eight-Slice phrase will loop rather than moving
forward continuously through the track.
Custom Pad Sets
In addition to the standard pad modes, you can create up to 3 customized Pad Sets using Serato DJ
Pro's MIDI mapping feature.
To create a custom pad set:
1. Hold Shift and press Cue / Pitch Play (1), Roll / Pad FX (3), or Sampler / Fader FX (4).
Note: If you have purchased the Serato Flip expansion pack, holding Shift and pressing
Sampler / Fader FX (4) will access the Flip Controls, not a custom pad set.
2. In Serato DJ Pro, open the Setup menu and select MIDI.
3. Select Seventy-Two and make sure that Allow Serato DJ Hardware Remapping is enabled.
Close the Setup window.
4. In the main Serato DJ Pro window, click the MIDI button at the top of the screen to begin
mapping.
5. Click a feature in Serato DJ Pro, then touch or move a control on your hardware to map the
feature to that control.
See the Serato DJ Pro manual for more information on MIDI mapping.
21