Rane Seventy-two Guide D'utilisation page 16

Pitch Play
In Pitch Play Mode, each pad plays the track from a
hot cue point at a different transposition (adjustable
by semitones). The Serato Pitch 'n Time DJ
Expansion Pack must be installed to use this mode.
See Cue to learn how to assign hot cue points.
Note: A Serato Pitch 'n Time download card with
serial number is included with your Seventy-Two.
To enter Pitch Play Mode, press Cue / Pitch Play
so that it lights green.
To select which hot cue point to use, press Shift
and a dimly lit Pad.
To select the range of transpositions the pads will
use, use the Parameter / buttons (see the
diagrams here).
To adjust the key of the current track down or up,
press Shift and the Parameter / buttons,
respectively.
To play the track from the hot cue point, press a lit
Pad. Each pad corresponds to a specific transposition
(by semitones), depending on the current range of
transposition (see the diagrams here). The pad with no
transposition (the original pitch) will be lit white.
Auto Loop
In Auto Loop Mode, each pad triggers or releases an auto-loop of a different length. The software's
loop grid determines the size of the loop.
To enter Auto Loop Mode, press Auto Loop / Man Loop so that it lights dark blue.
To change which eight lengths for auto loops are shown (in the software), press either of the
Parameter / buttons. The pad layout will shift to match it.
To shift the Auto Loop backward or forward, press Shift and the Parameter / buttons,
respectively.
16
+4 +5
semitones semitones
0
+1
(original
semitone
pitch)
Middle
0
+1
(original
semitone
pitch)
-4 -3
semitones semitones
Down
-3 -2
semitones semitones
-7 -6
semitones semitones
Up
+6 +7
semitones semitones
+2 +3
semitones semitones
+2 +3
semitones semitones
-2 -1
semitones semitone
0
-1
(original
semitone
pitch)
-5 -4
semitones semitones