Rane Seventy-two Guide D'utilisation page 18

Pad FX
In Pad FX Mode, the pads select and activate effects.
The top row of pads selects the type of effect, and
the bottom row triggers and controls the length of the
effect.
To enter Pad FX mode, press Roll / Pad FX so that
it lights yellow.
To select the Vinyl Brake effect, press Pad 1. When
the Vinyl Brake effect is triggered by the bottom row
pads, the audio slows as if a phono platter has
stopped, fading out to silence after the time selected.
To select the Backspin effect, press Pad 2. When the Backspin effect is triggered by one of the
bottom row pads, the audio plays backwards and speeds up as if a phono platter is spun
backwards, fading out to silence after the time selected.
To select the Gate effect, press Pad 3. When the Gate effect is triggered by one of the bottom row
pads, a time-based gate is applied to the audio based on the selected size.
To select the Echo effect, press Pad 4. When the Echo effect is triggered by the bottom row pads,
the audio will echo to silence based on the size selected.
Note: The Echo effect can be combined with other effects. All other effects are exclusive.
To trigger the selected effect, press one of Pads 5–8. Each pad activates the effect immediately
with a set size, increasing from Pad 5 (shortest time) to Pad 8 (longest time). When an effect is
triggered, the selected pad will blink.
Note: Selecting a new pad mode will disable all currently active Pad FX on that deck.
Sampler
In Sampler Mode, the pads will control the sampler in the software. The pads each trigger a sample
at a specified volume (you can assign the sample and its volume in the software).
To enter Sampler Mode, press Sampler / Fader FX so that it lights purple.
To assign a sample, first highlight the desired sample in your library. Then hold Shift and press a
pad corresponding to an empty sampler slot. The sampler slot volume can be adjusted in Serato.
To play a sample, press a lit pad. The pad will flash as the sample plays.
To stop playback of a sample, press Shift and a Pad while it plays.
To cycle through the sample banks, press the Parameter / buttons.
To cycle through the Sampler outputs, press Shift and the Parameter / buttons.
18
2
1
Vinyl
Backspin
Brake
5 6
Size 1 Size 2
4
3
Gate Echo
7 8
Size 3 Size 4