Assistance And Repairs; Warranty Coverage; Maintenance Table - Stiga ST 526 S ST 4262 P Manuel D'utilisation

8. STORAGE
When you intend to put your machine
away for more than 30 days:
1. Empty the fuel supply circuit:
– Close the fuel tap (fig. 15.B).
– Start the machine's engine and leave
it running until it runs out of fuel.
2. Change the engine oil if this operation has
not been done in the last three months.
3. Clean the snow thrower thoroughly.
4. Check for any damage. If necessary,
see to the necessary repairs.
5. If the paintwork is damaged,
touch it up to prevent rust.
6. Protect any exposed metal surfaces from rust.
7. Store the snow thrower indoors if possible

9. ASSISTANCE AND REPAIRS

This manual provides all the necessary
information to run the machine and for correct
basic maintenance operations which can
be performed by the user. Any regulations
and maintenance operations not described
herein must be carried out by your Dealer
or Authorised Service Centre, which have
the necessary knowledge and equipment to
ensure that the work is carried out correctly,
maintaining the correct degree of safety and the
original operating conditions of the machine.
Any operations performed in unauthorised
centres or by unqualified persons will totally
invalidate the Warranty and all obligations
and responsibilities of the Manufacturer.
• Only authorised service workshops can carry
out guaranteed repairs and maintenance.
• The authorised service workshops
only use genuine spare parts. Genuine

11. MAINTENANCE TABLE

Intervention
MACHINE
Check all fasteners
Safety checks/check controls
General cleaning and inspection
Cleaning the discharge area
Lubrication of the drive shaft.
*** Interventions which must be carried out by your dealer or an authorised assistance centre
spare parts and attachments have been
designed specifically for machines.
• Non-genuine spare parts and attachments are
not approved. Use of non-genuine spare parts
and attachments cause the warranty to expire.
• It is advisable to send your machine
once a year to an authorised service
workshop for servicing, assistance
and safety device inspection.

10. WARRANTY COVERAGE

The warranty covers all material and
manufacturing defects. The user must
follow all the instructions provided in
the accompanying documentation.
The warranty does not cover
damages caused by:
• Failure to become familiar with the
documentation accompanying the machine.
• Carelessness.
• Incorrect or prohibited use or assembly.
• Use of non-genuine spare parts.
• Use of attachments not supplied or
approved by the manufacturer.
The warranty does not cover:
• Normal wear and tear of consumables,
such as drive belts, drills, headlights,
wheels, bolts and wires.
• Normal wear and tear.
• Engines. Engines are covered by
the warranty provided by the relative
manufacturer in compliance with the
specified terms and conditions.
The purchaser is protected by his own national
legislation. The purchaser's rights envisaged
by the national laws in his own country are
not in any way restricted by this warranty.
Frequency
First time
-
-
- Cleaning the exhaust area
- 5 hours / after each use
- 25 hours / every season
EN - 13
An then after
Before each use
Before each use
Paragraph
7.7
6.2
7.4
7.4
***