iwc Mark XV 3253 Mode D'emploi page 14

Attaching the bracelet
Attach the component parts of the
bracelet link to the connection point,
and push the pivot pin into the
bracelet from the side opposite the
marking until the pivot pin projects
by about 3 mm.
Using the special tool provided, now
press the securing pin downwards
and, at the same time, slide the pivot
pin back into the bracelet until it lies
flush.
The securing pin must be brought
up flush with the upper edge of
the securing link. Please be sure
to check the correct seating of the
pivot pin.
Status September 2000.
Technical specifications subject to change.
24 | 25